LPC2124波形发生器设计，keil编程,protues硬件图
LPC2124 waveform generator design, keil programming, protues hardware chart (2013-09-23, C/C++, 666KB, 下载3次)
是使用stm32编写的数字示波器，可以显示波形，计算峰峰值，计算频率，如果液晶不能点亮，请更换自己液晶对应的驱动
Stm32 prepared using digital oscilloscope can display waveforms, peak calculation, calculate the frequency, if the LCD is not lit, replace their corresponding drive LCD (2013-07-26, C/C++, 2083KB, 下载124次)
本文档包括波形发生器和峰值电压数字检测器的proteus仿真图和源程序
This document includes a waveform generator and the peak voltage of digital detector proteus simulation diagram and source program (2012-12-20, C/C++, 112KB, 下载16次)
基于STM32的PWM波形发生，可按键调频，内含死区，死区时间可更改。
Based STM32 PWM waveform occurred, may be the key FM containing dead zone, the dead time can be changed. (2012-10-17, C/C++, 1152KB, 下载23次)
利用mcp41010和小型开发板实现一函数发生器，频率较低。但波形效果不错
Mcp41010 and small development board to achieve a function generator, and less frequently. However, waveform well (2012-08-07, C/C++, 30KB, 下载9次)
信号发生器，基于dds信号发生器，1602显示，按键输入。
Signal generator, signal generator based dds, 1602 display, key input. (2011-10-03, C/C++, 3908KB, 下载25次)
关于dds芯片ad9910的驱动代码和spi设计程序.相当全面!
About dds ad9910 chip spi driver code and design process. Quite comprehensive! (2011-09-24, C/C++, 137KB, 下载74次)
波形发生器的使用和产生波形的主要原理的进行分析与数据处理
Waveform generator produces waveforms used and the main principles of analysis and data processing (2011-08-16, C/C++, 3KB, 下载2次)
STM32内部AD采样实现简易电压表(同时显示直流电压波形).c
stm32adc voltage (2011-07-19, C/C++, 6KB, 下载29次)
产生DDS信号，如各个频率的正弦波或者方波既三角波等等
DDS generated signals, such as different frequency sine wave or square wave triangle wave, and so both (2011-03-22, C/C++, 17KB, 下载3次)
DDS是在数字电路与实际应用中越来越受重视，无论是在FPGA或者DSP中总能用到它，这里是DDS的一些资料
DDS is in the practical application of digital circuits with more and more attention, both in total FPGA or DSP can be used to it, here is some information on DDS (2010-09-04, C/C++, 1588KB, 下载2次)
DDS信号发生器AD9854驱动程序源代码
The Signal Gerneration of DDS Using AD9854 Driver Source Code (2009-11-25, C/C++, 4KB, 下载9次)
使用C51单片机控制操作DDS芯片AD9835
C51 MCU control operations using the DDS chip AD9835 (2009-08-28, C/C++, 21KB, 下载41次)
用LM3S1138来控制DDS芯片ad9850产生扫频波信号，修改程序中的控制字可调整扫频波的分辨率。
With the LM3S1138 to control the DDS chip ad9850 sweep wave signal generated, modify the program control word adjustable sweep wave resolution. (2009-08-27, C/C++, 42KB, 下载9次)
基于ADuc7026的DDS AD9851驱动程序，频率范围0到30M
ADuc7026 based on the DDS AD9851 driver, a frequency range of 0 to 30M (2009-08-19, C/C++, 50KB, 下载4次)
信号发生器，可以产生，多种波形，正弦波，方波，锯齿波等波形，可以实现调频，调幅
Signal generator, can produce a variety of waveforms, sine wave, square wave, sawtooth wave, etc., can be FM, AM (2009-08-10, C/C++, 124KB, 下载18次)
stm32采样波形同时在液晶上显示出来 并计算出频率
stm32 sampling the waveform at the same time in the liquid crystal display and calculate the frequency of (2009-07-16, C/C++, 1710KB, 下载352次)
dds集成芯片ad9851的控制程序，可用1602液晶显示
ad9851 chip dds control procedures that can be used liquid crystal display 1602 (2009-05-09, C/C++, 38KB, 下载6次)
单片机应用 c语言编写
注释详细
基于AD9850的数字信号发生器
Single-chip Microcomputer Application Notes details c language based on the AD9850 digital signal generator (2008-10-13, C/C++, 1KB, 下载52次)
本代码是用单片机控制DDS芯片输出DDS信号 。该信号包括FSK调制信号和线性调频信号
This code is used to control single-chip DDS chip DDS output signal. The signal including the FSK modulation signal and linear FM signal (2008-10-10, C/C++, 2KB, 下载43次)