交通仿真软件说明书,微观交通流模拟，路网仿真
traffic simulation manual (2017-07-14, Unix_Linux, 1473KB, 下载22次)
7601驱动，官网下载的！非常好用！已经用在TI开发板上面了
7601 drive, the official website to download! Very easy to use! TI has been used in the above board (2016-05-19, Unix_Linux, 1571KB, 下载28次)
基于libpcap抓包原理，解析以太网、ip、tcp协议，捕获相关协议信息。适合网络数据抓包初学者。
Based on the principle of libpcap capture, parse Ethernet, ip, tcp protocol, capture the relevant protocol information. Network data capture for beginners. (2015-10-27, Unix_Linux, 2KB, 下载6次)
moxa网口转串口在Linux下的驱动程序。支持kernel2.6内核。
moxa network port to serial port driver under Linux. Support kernel2.6 kernel. (2015-06-11, Unix_Linux, 57KB, 下载13次)
ser2net的最新版本，这是一个串口转以太网的程序~可能在嵌入式系统用的比较多，linux C编程
The latest version ser2net s (November 2015), for serial to Ethernet, I cross-compile and test it in the mips, with good results (2015-05-15, Unix_Linux, 356KB, 下载4次)
MAX number of INT_REDUCE_CONTROL registers.
MAX number of INT_REDUCE_CONTROL registers.
(2014-10-30, Unix_Linux, 6KB, 下载1次)
无线自组网中，最优链路状态路由，olsr协议linux代码，网站上下载的，希望对大家有用。
Optimized Link State Routing Protocol 最优链路状态路由协议 in ad hoc networks (2014-10-24, Unix_Linux, 7376KB, 下载21次)
华为西门子模块，gprs连接到核心网，打通数据通道
gprs connection (2013-08-21, Unix_Linux, 19KB, 下载1次)
以太网通信cs8900控制芯片驱动c程序源码
Ethernet communications controller chip cs8900 driver c program source code (2011-10-30, Unix_Linux, 4KB, 下载4次)
以太网控制LInux系统下驱动程序，文件名stream_data.c
Ethernet control system LInux driver (2011-08-27, Unix_Linux, 2KB, 下载6次)
本文正是基于以上背景，以使嵌入式设备能够脱离PC通过嵌入式USB主机/以
太网控制器接入网络通信，设计了基于32位处理器ARM920T内核和Cs8900A以
太网控制器芯片的USB/以太网协议转换系统。
This article is based on the above background, so that from the PC to embedded devices with embedded USB host/Ethernet access network communication controller is designed based on a 32-bit ARM920T processor core and Cs8900A USB Ethernet controller chip/Ethernet protocol conversion system. (2011-06-05, Unix_Linux, 5388KB, 下载6次)
自己做的在ARM上的网口驱动， 经过测试完全通过………………
ARM linux for 2.6 (2011-01-29, Unix_Linux, 16KB, 下载4次)
RTL8019作为以太网的物理层接口。主要功能包括物理编码子层、物理媒体附件、双绞线物理媒体子层、双绞线媒体访问单元等。
RTL8019基本工作原理是：在收到由主机发来的数据报后，侦听网络线路。如果线路忙，就等到线路空闲为止，负责立即发送该数据帧。发送过程中，首先添加以太网帧头，然后生成CRC校验码，最后将此数据帧发送到以太网上。
RTL8019 (2010-05-19, Unix_Linux, 3KB, 下载10次)
无线网功率控制的几种性能指标概述(.doc)
Several power control of wireless network performance overview (. Doc) (2010-04-16, Unix_Linux, 215KB, 下载13次)
基于QQ2440 ARM开发板的实时绘制曲线图的QT程序，从ARM板上的串口接收数据后，绘制曲线图形，然后利用网口将数据传输到PC机上。
QQ2440 ARM development board based on real-time rendering curve of the QT program, from the ARM-board serial port to receive data, draw curve graph, then use the Ethernet port to transfer data to PC. (2009-12-27, Unix_Linux, 3KB, 下载44次)
3gpp WCDMA核心网 GGSN gn接口实现源码
3gpp WCDMA Core Network GGSN gn interface Source (2009-09-05, Unix_Linux, 163KB, 下载116次)
It is geared to an audience of both corporate as well as home users. It is not intended to be a full overview of Unix operations, as there are several good texts available as well as on?line documentation which can be referred to in cases where more detailed information is required.
In general, your Linux system can operate with a minimum of user maintenance. Routine tasks, such as rotating and discarding of system logs, are automated. Therefore, for the most part, even with very little user intervention, Linux will hum along doing its job. However, in cases of custom needs or system failure this documentation may prove useful.
It is geared to an audience of both corporate as well as home users. It is not intended to be a full overview of Unix operations, as there are several good texts available as well as on?line documentation which can be referred to in cases where more detailed information is required.
In general, your Linux system can operate with a minimum of user maintenance. Routine tasks, such as rotating and discarding of system logs, are automated. Therefore, for the most part, even with very little user intervention, Linux will hum along doing its job. However, in cases of custom needs or system failure this documentation may prove useful.
(2009-09-02, Unix_Linux, 1317KB, 下载3次)
基于sep4020的以太网驱动，在linux下运行
Sep4020 based on the Ethernet driver, running under the linux (2009-08-05, Unix_Linux, 11KB, 下载2次)
路由器通常用于节点众多的大型网络环境，它处于ISO/OSI模型的网络层。与交换机和网桥相比，在实现骨干网的互联方面，路由器、特别是高端路由器有着明显的优势。路由器高度的智能化，对各种路由协议、网络协议和网络接口的广泛支持，还有其独具的安全性和访问控制等功能和特点是网桥和交换机等其他互联设备所不具备的。路由器的中低端产品可以用于连接骨干网设备和小规模端点的接入，高端产品可以用于骨干网之间的互联以及骨干网与互联网的连接。特别是对于骨干网的互联和骨干网与互联网的互联互通，不但技术复杂，涉及通信协议、路由协议和众多接口，信息传输速度要求高，而且对网络安全性的要求也比其他场合高得多。因此采用高端路由器作为互联设备，有着其他互联设备不可比拟的优势。
err (2008-11-23, Unix_Linux, 450KB, 下载12次)
基于S3C4510B的以太网协议的移植，适用于三星ARM7核心的S3C4510B开发板，其他ARM7可参考
S3C4510B based on the Ethernet protocol transplant applies to the Samsung S3C4510B ARM7 core development board, other ARM7 reference (2005-11-26, Unix_Linux, 95KB, 下载46次)