[嵌入式/单片机/硬件编程] Double Pulse
此程序位IGBT 双脉冲测试程序。 第一个脉宽30us 第二个脉宽10us 并且给出了实验波形 包括脉冲波形和IGBT的工作波形
The program a IGBT double pulse test program. The first pulse width 30 us the second pulse width 10 us And the experimental waveforms Including pulse waveform and IGBT work (2020-07-06, C/C++, 8KB, 下载0次)
[嵌入式/单片机/硬件编程] test
用单片机编程实现常用波形的产生（锯齿波、三角波、方波、正弦波）
The generation of common waveforms (sawtooth wave, triangle wave, square wave and sine wave) is realized by single chip microcomputer programming (2020-06-14, C/C++, 16KB, 下载1次)
[嵌入式/单片机/硬件编程] 8FinSH波形切换
FinSH控制台，三角波和正弦波切换，通过发送指定命令，实现波形输出的转换。
Finsh console, triangle wave and sine wave switching.The conversion of waveform output is realized by sending the specified command. (2020-03-29, C/C++, 1754KB, 下载0次)
[嵌入式/单片机/硬件编程] lesson17_3 - 单个字符
接到单片机上后，输出到示波器可以看到一定频率的方波，通过按键可以调节波形的频率，同时在显示屏上也可以产生对应的周期和频率，外加信号发生器，可以得出对应的周期频率
After being connected to the single chip computer, the square wave of a certain frequency can be seen when it is output to the oscilloscope. The frequency of the waveform can be adjusted by keystrokes. At the same time, the corresponding period and frequency can be generated on the display screen, and the corresponding periodic frequency can be obtained by adding a signal generator. (2019-08-10, C/C++, 118KB, 下载1次)
[嵌入式/单片机/硬件编程] DA例程
正确配置P0.26引脚，实现DA输出功能，并用示波器观测输出波形
Correctly configure P 0.26 pin to realize DA output function and use oscilloscope to observe output waveform (2018-12-20, C/C++, 80KB, 下载0次)
[嵌入式/单片机/硬件编程] stm32示波器试验程序
本程序提供了一个示波器显示程序，在STM32单片机上实现，能较好的仿真出三种波形
This program provides an oscilloscope display program, which is implemented on STM32 single chip microcomputer and can simulate three kinds of waveforms better. (2018-06-05, Others, 2421KB, 下载7次)
[嵌入式/单片机/硬件编程] 51黑论坛_2myDAC_timer-wave-struct
使用stm32中的dac和dma产生一个可调的信号
Use DAC and DMA in STM32 to produce an adjustable signal. (2018-05-18, C/C++, 327KB, 下载1次)
[嵌入式/单片机/硬件编程] My_MiniSTM32VET_ECG_uCGUI_DEMO(OK)
实显示采集到的心电波形信号，有SD卡存储和USB数据传输功能
Real display collected ECG signal, SD card storage and USB data transfer function (2015-06-30, Visual C++, 3651KB, 下载15次)
[嵌入式/单片机/硬件编程] MSP430F6638_Demo_V2.1.1
Msp430F6638完整的例程包括水灯,按钮中断,定时器,PWM发生器、uart、RTC,液晶测试等等。
Msp430F6638 full routines including water lights, button interrupt, timer, PWM generator, uart, RTC, LCD test and so on.
(2013-11-27, Visual C++, 17269KB, 下载45次)
[嵌入式/单片机/硬件编程] digital-signal-generator-
基于凌阳61单片机的数字信号发生器，可生成三角板，方波，矩形波
Sunplus 61 microcontroller-based digital signal generator to generate the triangle, square wave, rectangular wave (2012-05-19, C/C++, 1710KB, 下载8次)
[嵌入式/单片机/硬件编程] Nios
基于软核Nios的宽谱正弦信号发生器设计 柴油机振动信号分析程序
Nios soft core based on a wide spectrum of sinusoidal signal generator diesel engine vibration signal analysis program designed (2011-04-20, IDL, 3380KB, 下载9次)
[嵌入式/单片机/硬件编程] Pumplementation
纯音听力计中纯音信号发生器的设计与实现Pure tone audiometer pure tone signal generator in the Design and Implementation
Pure tone audiometer pure tone signal generator in the Design and Implementation (2011-01-21, C++ Builder, 725KB, 下载11次)
[嵌入式/单片机/硬件编程] cpu
包括1) 时钟发生器
2) 指令寄存器
3) 累加器
4) RISC CPU算术逻辑运算单元
5) 数据控制器
6) 状态控制器
7) 程序计数器
8) 地址多路器
1) clock generator 2) instruction register 3) accumulator 4) RISC CPU arithmetic logical unit 5) of the data controller 6) state controller 7), the program counter 8) address multiplexer (2010-07-05, VHDL, 430KB, 下载33次)
[嵌入式/单片机/硬件编程] cunchuqi
用于仿真验证的存储器实验电路图,用于下载验证的存储器实验电路图,用MAX+PLUSII或QUARTUS4.0软件完成存储器实验电路图,仿真波形
Simulation experiments for the memory circuit, used for downloading memory validation test circuit, using the software MAX+ PLUSII or QUARTUS4.0 complete memory test circuit, simulation waveforms (2009-12-10, Others, 66KB, 下载4次)
[嵌入式/单片机/硬件编程] dds31
FPGA单片机开发
正弦波 方波 三角波 信号发生器
按键用单片机控制
FPGA Microcontroller Development sine square triangular wave signal generator control buttons with SCM (2009-10-07, C/C++, 2KB, 下载38次)
[嵌入式/单片机/硬件编程] DrawCurve
利用EVC编的示波器程序，实时显示波形，全部原代码都在压缩包里
Part of the oscilloscope using EVC procedures, real-time display waveforms, all of the original code in the compressed bag (2009-09-02, C/C++, 72KB, 下载26次)
[嵌入式/单片机/硬件编程] zhengxuanxinhao
这是一个正弦信号发生器得总程序，是用51单片机实现的，控制ad9852，
This is a sinusoidal signal generator was the total program, is 51 single-chip microcomputer, the control of ad9852, (2009-08-28, Visual C++, 51KB, 下载54次)
[嵌入式/单片机/硬件编程] sin
基于单片机的四路相位相差90度的信号发生器，可模拟光栅传感器的输出信号
Based on the four-way single-chip 90-degree phase difference between the signal generator, can simulate the grating sensor output signal (2009-07-03, Visual C++, 17KB, 下载11次)
[嵌入式/单片机/硬件编程] 2008-04-23
这是一整套USB2.0试验程序，包括单片机程序（用的是C8051F020），USB2.O芯片（68013）的固件，PC端读取USB数据并画波形的程序（VC编写）。这套程序实现了单片机和PC的USB通讯，可以帮助初学的朋友入门。
This is a set of testing procedures USB2.0, including single-chip process (using the C8051F020), USB2.O chips (68,013) of the firmware, PC-side USB read waveform data and the procedures for painting (VC preparation). This set of procedures to achieve a single chip and PC' s USB communications, a friend can help novice entry. (2009-05-15, C/C++, 4187KB, 下载252次)
[嵌入式/单片机/硬件编程] Labview.chuankou
运用Labview进行虚拟示波器串口设计的源码
The use of Labview virtual oscilloscope serial design source (2008-03-13, LabView, 97KB, 下载672次)