用于dsp芯片的adc采样，使用GPIO2作为ePWM2a功能引脚，输出方波信号，
将该信号接至ADCINA0，经由ADC采样后，再做FFT分析。
DSP引脚输出高电平为3.3V，而片上ADC最大采样输入
电压为3V，所以会导致采样值饱和，但因GPIO2输出的
是方波信号，所以采样饱和并不影响FFT的谱分析
（相当于采样后是0~3V的矩形波）。读者也可外接信
号发生器，将信号接至ADC转换通道进行实验。
ADC sampling for DSP chip (2020-04-27, Others, 1KB, 下载1次)
逆变器控制仿真编程，逆变器早期故障预测仿真，采用新方法
Control simulation of inverter (2018-03-06, C/C++, 524KB, 下载9次)
单相并网逆变器代码，PI控制加电网电压前馈控制，LCL滤波器
Single-phase grid-connected inverter code, plus feedforward control PI control grid voltage, LCL filter (2016-11-01, C/C++, 498KB, 下载69次)
LG变频器源码，100kW，VVVF，矢量控制等
LG inverter (2015-03-02, C++, 1186KB, 下载58次)
这是一个利用DSP28335来产生PWM控制波形的资料，有各模块的介绍，比较详细。
This is a use of DSP28335 to generate PWM control waveform data, with each module is introduced, compared with (2014-12-10, PDF, 567KB, 下载72次)
单相逆变器并网控制，单相逆变器并网控制，单相逆变器并网控制
Single-phase inverter grid-controlled, single-phase inverter grid-controlled, single-phase inverter and network control (2013-07-18, matlab, 8KB, 下载136次)
此程序是实现DSP中的AD模块（AD采样）以及SPWM波形的产生以及SCI模块（DSP与上位机的通信）
This program is of DSP AD module (AD sampling), and SPWM waveform of generated and SCI module (DSP and host computer communication) (2013-05-09, C++, 2424KB, 下载17次)
MATLAB simulink仿真spwm逆变器
MATLAB simulink (2013-05-03, matlab, 37KB, 下载129次)
变频器控制程序用DSPIC30F5015
Inverter control program with DSPIC30F5015 (2013-02-26, Others, 182KB, 下载14次)
AD采样频率为10K，序列发生器SEQ1和SEQ2级联成一个16通道的序列发生器，采样模式采用顺序采样。利用通用定时器T1的周期中断事件来启动AD转换。ADCINA0和ADCINB0为参考电平，实际的电压值分别为0.420和1.653,由于每个板子的具体特性稍有不同，请用万用表自行测量参考电压值。此例程对ADCINA0、ADCINA1、ADCINB0、ADCINB1四个通道进行连续10次的采样，然后对各个通道的10个采样值进行排序，滤波，最后取平均值。然后由ADCINA0和ADCINB0通道的值计算求得CalGain和CalOffset，最后由这两个量来校正ADCINA1和ADCINB1。
AD sampling frequency for the 10K, the sequence generator SEQ1 and SEQ2 cascade into a 16-channel sequencer, sampling mode with sequential sampling. The use of general-purpose timer T1 cycle to start AD conversion interrupt event. ADCINA0, and ADCINB0 as the reference level, the actual voltage values of 0.420 and 1.653, respectively, due to the specific characteristics of each board is slightly different, with a multimeter self-measurement of the reference voltage value. This routine ADCINA0, ADCINA1, ADCINB0, ADCINB1 four channel continuous sampling of 10 times, and then sort the sampled values of the respective channels 10, filtering, and finally take the average. Then to calculated to obtain the CalGain and CalOffset by ADCINA0, and ADCINB0 channel value, the final by these two quantities to to correction ADCINA1 and ADCINB1. (2012-11-04, C/C++, 477KB, 下载19次)
逆变器单项调制程序，基于tms320f2812
Inverter single modulation procedure, based on tms320f2812 (2012-07-31, C/C++, 311KB, 下载13次)
变频器主程序。PIDSP30F2010主芯片
Inverter main PIDSP30F2010 (2011-12-28, Asm, 1KB, 下载19次)
DSP-2812的变频器源码，用dsp2812做的变频器源码和protel原理图，说明书等，不错的资料
dsp-2812 Variable-frequency Drive (2011-12-08, Asm, 9603KB, 下载488次)
变频器设计，基于DSP2407的变频器软件系统程序源码，包含流程图
Based on the design, DSP2407 inverter frequency converter software system program source code, contains flowchart
(2010-12-23, Others, 186KB, 下载199次)
一个关于数字信号处理中FIR算法的c语言源程序，可以通过在TI公司的CCS软件中硬件仿真或软件仿真产生波形
On digital signal processing algorithm in the FIR of the c language source code is available through the TI' s CCS software or hardware simulation software simulation waveforms generated (2009-04-17, C/C++, 1KB, 下载8次)
可以应用在C5402上，基于查表的DSP正弦信号发生程序，用c编写，经测试可直接在ccs上运行。
Can be applied to the C5402, the DSP-based sinusoidal signal look-up table programmed with c prepared by the test can be run directly in the ccs. (2008-12-10, C/C++, 16KB, 下载47次)
矢量变频器源程序 DSP为TMS320F240
Vector Inverter DSP source code for TMS320F240 (2008-10-22, Others, 6KB, 下载135次)
典型的采样数据DSP系统 实际模拟到数字的转换之前，模拟信号一般要经过某些种类的信号调节电路，这些信号要执行像放大、衰减和滤波这样的功能。需要用低通/带通滤波器把不需要的信号从有用带宽中消除掉，并能防止混叠发生
Typical sampled data DSP system, the actual analog-to-digital conversion before the analog signal in general has to go through certain types of signal conditioning circuits, these signals to perform as amplification, attenuation and filtering such functions. Need to use low-pass/band-pass filter the unwanted signal from the useful bandwidth to eliminate out, and to prevent the occurrence of aliasing (2008-09-18, Others, 146KB, 下载11次)
基于DSP TMS320LF2407A变频器源程序
Source inverter based on DSP TMS320LF2407A (2008-03-20, Others, 184KB, 下载510次)
基于调幅和调频的基本原理，运用产生信号的两种基本方法，使用CCS软件以及Digital Signal Processor实现调幅调频信号的发生。
AM and FM based on the basic principles of the use of signals generated in two basic methods, the use of CCS as well as the Digital Signal Processor software realize the occurrence of AM FM signal. (2008-03-09, C/C++, 341KB, 下载6次)