Two 1-bit full subtracters are constructed by integrated binary decoder and NAND gate
Two 1-bit full subtracters are constructed by integrated binary decoder and NAND gate (2021-04-21, Multisim, 187KB, 下载0次)
经典的采用比较器作为高压保护电路的原理图方案
Scheme of using comparator as high voltage protection circuit (2021-03-15, Multisim, 273KB, 下载1次)
给出了巴特沃兹有源低通滤波器的设计方法和设计实例,通过multisim电路仿真试验能够得到一个性能优良的有源低通滤波器。
The design method and example of Butterworth active low-pass filter are given. Through Multisim circuit simulation test, an active low-pass filter with excellent performance can be obtained. (2021-01-12, Multisim, 130KB, 下载0次)
稳压器,用于验证加入反馈前后，电路各指标状态，以及检测是否超出最大稳压范围
voltage regulator,It is used to verify the state of each index of the circuit before and after adding feedback, and to detect whether it exceeds the maximum voltage range (2020-12-29, Multisim, 1139KB, 下载0次)
数电仿真8路呼叫器的设计与实现。使用MUltisium进行设计与实现。
The design and implementation of 8-way pager based on digital electric simulation. Design and implementation using multisium. (2020-12-24, Multisim, 12964KB, 下载1次)
通过multisim仿真出的交流自锁互锁文件，仅供学习研究
Through Multisim Simulation of the AC self-locking interlocking file, only for learning and research (2020-12-20, Multisim, 150KB, 下载0次)
全桥LLC变换器仿真电路，用psim搭建
Full bridge LLC circuit simulation (2020-09-24, Multisim, 9966KB, 下载12次)
74ls161计数器的multisim仿真。帮同学做的，顺便拿出来共享，希望对大家有帮助。
Multisim simulation of 74ls161 counter. Do it for classmates, share it by the way, hope it will be helpful to everyone. (2020-08-02, Multisim, 213KB, 下载3次)
交通灯课程设计:本设计是基于数字电路芯片完成的，内有Multisim仿真电路（已验证通过），具体设计说明书，基本思路采用74LS160十进制加法计数器来产生四种交通灯状态，计数器是由多功能计数器555产生的1Hz的秒脉冲驱动，希望能对你有所帮助。
Traffic light course design: This design is based on the digital circuit chip, with Multisim Simulation circuit (verified), the specific design specification, the basic idea is to use 74ls160 decimal addition counter to generate four traffic light States, the counter is driven by the 1 Hz second pulse generated by the multi-function counter 555, hoping to help you. (2020-07-02, Multisim, 460KB, 下载9次)
１．进一步熟悉高频电子线路仿真方法。
２．理解集电极调幅电路的工作原理，熟悉工程分析法。
3．进一步熟悉调幅波中调幅系数的定义及其测量方法。
4．了解四个电压量对集电极调幅电路的影响。
5．了解输出波形失真的原因及消除办法。
1. Be familiar with the simulation method of high frequency electronic circuit. 2. Understand the working principle of collector am circuit and be familiar with engineering analysis method. 3. further understand the definition of amplitude modulation coefficient and its measurement method in am wave. 4. Understand the influence of four voltage quantities on the collector am circuit. 5. Understand the causes of output waveform distortion and the elimination methods. (2020-03-10, Multisim, 2905KB, 下载1次)
0.1-30hz带通滤波器，多用于医用采样滤波的采样装置中
0.1-30hz band-pass filter (2019-04-25, Multisim, 144KB, 下载3次)
本人自己设计的逆变器仿真 可供初学者借鉴参考
The simulation of inverter designed by myself can be used for reference by beginners. (2019-02-16, Multisim, 932KB, 下载7次)
交通灯的设计与实现，用了3-8译码器等等，我实在不知道写啥
Design and implementation of traffic lights... (2018-12-28, Multisim, 69KB, 下载1次)
该资料为一款数字并网逆变器的信号调理电路原理图，用Altium可以打开
This data is a signal conditioning circuit schematic diagram of a digital grid-connected inverter, which can be opened by Altium. (2018-12-27, Multisim, 39KB, 下载7次)
振荡器是用来产生重复电子信号（通常是正弦波或方波）的电子元件。其构成的电路叫振荡电路.自激多谐振荡器也叫无稳态电路.两管的集电极各有一个电容分别接到另一管子的基极,起到交流耦合作用,形成正反馈电路,当接通电源的瞬间,某个管子先通,另一只管子截止,这时,导通管子的集电集有输出,集电极的电容将脉冲信号耦合到另一只管子的基极使另一只管子导通.这时原来导通的管子截止.这样两只管子轮流导通和截止,就产生了振荡电流.
Oscillators are electronic components used to generate repetitive electronic signals (usually sinusoidal or square waves). The circuit is called oscillating circuit. Self-excited multivibrator is also called unsteady circuit. Each collector of two tubes has a capacitor connected to the base of another tube, which acts as AC coupling and forms a positive feedback circuit. When the power supply is switched on, one tube opens first and the other tube cuts off. At this time, the collector of the conducting tube collects and transfers electricity. The capacitance of the collector couples the pulse signal to the base of another tube to make the other tube open. At this time, the original tube is cut off. Thus, the two tubes turn on and off, resulting in oscillating current. (2018-12-09, Multisim, 573KB, 下载1次)
实现滞回比较器,国家竞赛时使用的，效果良好，值得得到
The implementation of hysteresis comparator, which is used in national competition, achieves good results and deserves to be obtained. (2018-05-30, Multisim, 141KB, 下载3次)
超低频滤波器，-3dB截止频率达到25mhz
Ultra-low frequency filter, -3db cut-off frequency up to 25mhz. (2018-03-12, Multisim, 177KB, 下载5次)
很好的一篇直流变换器的文章，值得看，很好的学习材料
A good article in a DC converter (2018-03-11, Multisim, 5591KB, 下载3次)
运放的使用
运算放大器，对于学工科的学生来说是一个耳熟能详的词。运算放大器作为最通用的模拟器件，广泛运用于信号变换调理、ADC采样前端和电源电路等场合。大家在学习模电课程的时候，都已经学会了运放的设计。然而在使用运放的时候，又有哪些需要注意的呢？
Use of op amp
An operational amplifier is a familiar word for students in the engineering department. As the most common simulator, operational amplifier is widely used in signal processing and conditioning, ADC sampling front end and power supply circuit. We have learned the design of the operational amplifier when we are studying the course of modeling and electricity. But what do you need to pay attention to when using op amp? (2018-03-01, Multisim, 294KB, 下载5次)
基于无线传感器网络LEACH协议的经典分簇算法。
Classical Clustering Algorithm Based on LEACH Protocol of Wireless Sensor Networks. (2017-11-02, Multisim, 13KB, 下载4次)